Contact
Series
G0.110

Venting of the spring area

of clamping elements and work supports
Venting of the spring area
Downloads
Catalogue sheet
Operating instructions
Available on demand.
Information Series
Introduction
G 0.110 Accessories for Venting of the Spring Area of Clamping Elements and Work Supports

Due to increased use of coolants and cutting fluids in metal cutting machining there is also an increased danger that some very aggressive fluids penetrate into the spring areas of single acting clamping elements and work supports, causing malfunctions.
It is important to realize these problems already in the period of design. The following versions show possible solutions to the above problems.

 

Why venting has to be made?

Excess pressure or depression 
in the spring area change the spring forces which leads to malfunctions.

Formation of condensation water
promotes rust formation and can lead to a complete failure of the elements.

Leakages
of hydraulic seals must drain off to the exterior without pressure, otherwise there will be malfunctions.

Dust and swarf
are retained by sintered metal air filters.

Liquids
are the real problem, because they are drawn off through the air filter. Thereby the breathing spring area is reduced, a higher excess pressure or depression is caused and the function is impaired.

 

 

Products (11)
Loading…
type
Item no. CAD datatype
Item no.
CAD data
/
type
empty housing 1.600 cm3
Properties
Item no.
CAD data
/
type
insertion nipple fitting M5
Properties
Item no.
CAD data
type
insertion nipple fitting 1/8
Properties
Item no.
CAD data
/
type
insertion nipple fitting 1/4
Properties
Item no.
CAD data
type
L-type insertion nipple fitting, swivelling M5
Properties
Item no.
CAD data
/
type
L-type insertion nipple fitting, swivelling 1/8
Properties
Item no.
CAD data
/
type
L-type insertion nipple fitting, swivelling 1/4
Properties
Item no.
CAD data
/
type
L-type insertion nipple distributor
Properties
Item no.
CAD data
/
type
hose connection, L-type 90°
Properties
Item no.
CAD data
/
type
plastic hose
Properties
Loading…
Item no.
type
empty housing 1.600 cm3
Item no.
type
insertion nipple fitting M5
Item no.
type
insertion nipple fitting 1/8
Item no.
type
insertion nipple fitting 1/4
Item no.
type
L-type insertion nipple fitting, swivelling M5
Item no.
type
L-type insertion nipple fitting, swivelling 1/8
Item no.
type
L-type insertion nipple fitting, swivelling 1/4
Item no.
type
L-type insertion nipple distributor
Item no.
type
hose connection, L-type 90°
Item no.
type
plastic hose